500mm-wide Tape Casting Sheet Coater (20"W°43"L) w/ 120°C Vac. Bed & Doctor Blade - MSK-AFA-W500-AL

• 208-240VAC, single phase, 50/60 Hz
• 2000W (heating bed)
• 120-240VAC, single phase, 50/60Hz
• 80W (24VDC power adapter) (non-heating bed)

• Touchscreen control panel for the settings of coating speed, distance, temperature, and vacuum. 
• Travel speed: 500 - 5000 mm/min
• Travel distance: 1 - 1000 mm
• Vacuum chuck temperature: 120ºC
• PID temperature control with an accuracy of ±1°C

• Aluminum alloy flat vacuum chuck
• Flatness: ±5 µm
• Vacuum chuck: L1100 ×W 550 mm 
• Vacuum area: L1000 × W500 mm
• Effective coating area: L1000 × W500 mm
• Max. heating temperature: 120°C

• Max. Area: 1000mm (L) x 350mm (W)
• Max Thickness: 500 microns with accuracy +/- 10 microns
• Note: Film thickness accuracy is strongly dependent on Slurry Viscosity. Slurry quality is very important for film quality.

• Stainless steel structure with 4 guiding wheels
• Slurry guiding plate for even distribution of slurry. 
• 500 mm coating width.
• Wet film thickness between 0 - 5000 microns.
• The two digital micrometers, 0-12.7 mm, ±5 µm

• Stainless steel structure with 4 guiding wheels
• Contactless coating for thin films
• 500mm coating width
• 2 sets of stainless steel shims: 0.2mm, 0.3mm, and 0.4mm
• The two digital micrometers, 0-12.7 mm, ±5 µm

• 120 L/min oilless vacuum pump
• Ø8mm OD gas tube

• IR light heating cover is available upon request at the extra cost ( click Pic left to see details)
• Digital temperature controller is built in ( single point control)
• Max. working temperature: 120oC
• Power: 220VAC +/- 10%, 50/60Hz, 2500W

• It is recommended to operate the coater under a fume hood. (Pic.1)
• A vacuum mixer is highly recommended for slurry degassing (Pic.2 )
• A Slurry Viscosity Tester is highly recommended for coatings consistent (Pic.3)
• A convection drying oven is recommended for long-time film drying and storage. (Pic.4)

     Pic.1 Pic.2  

• CE certified
• NRTL or CSA certification is available upon request at an extra cost. (based on UL61010/SPE-1000 regulation).