Hybrid Ultrasonic Spraying and Screen Printing Film Coater (100 mm x 100 mm) - MSK-AFA-MF100

• Two coating methods: screen printing and ultrasonic spray pyrolysis coating
• Adjustable spray speed and position for screen printing
• Adjustable moving track, feed rate, working height, and spray speed for ultrasonic spraying
• Easy-to-use Touch Screen Panel
• Vacuum chuck for holding the printing sheet faster and easier

• AC 110 - 220V±10% Single Phase, 50/60Hz, 280W

• Recommend substrate size: L100215mm x W100120mm
• Recommend slurry viscosity: 40008000 mPa.s
• Coating accuracy: ± 6?m (typical value)
• Coating thickness: 10200?m
• Coating speed: 132 mm/s adjustable

• Frequency: 50 kHz, Power: 20 W.
• Recommend substrate size: L100215mm x W100120mm
• Recommend slurry viscosity: ? 50 mPa.s
• Coating accuracy: ± 1?m (typical value)
• Coating thickness: 25100?m
• Coating speed: 132 mm/s adjustable

• A substrate is held by the vacuum chuck with an area of 150 x 150 mm (The vacuum pump is built-in)
• Heating Temperature: 120°C Max. with digital temperature controller

• 5 mm Max.

• 100 mm x 100 mm

• CE certified
• NRTL or CSA certification is available upon request at an extra cost.

Compressed Gas Requirement

 pic1 

 pic2

• 0.5-0.8 MPa pressure required
• The compressed air pump is required for the operation, but it is not included in the standard order, please click the link below to order one if you don't have.
• Attention: If a gas cylinder is used instead of air compressor(pic2), a two-stage pressure regulator(pic1) must be installed on the gas cylinder to limit the pressure within the required working range for safe operation. Click here to learn about the installation of a gas regulator.