MTI  |  SKU: DIE120D

4.7" ( 120 mm) I.D Dry Pellet Pressing Die - EQ-Die-120D

€2.297,70

Delivery and Shipping to EU

We will add in the quotation, the shipping, insurance, customs clearance costs.

4.7" ( 120 mm) I.D Dry Pellet Pressing Die - EQ-Die-120D

MTI

 SPECIFICATIONS:

Model    EQ-Die-120D
Height   60 mm (2 3/8")
Inside Diameter    120mm (4 3/4")
Outside Diameter   200 mm (8")
Net Weight   86 Lbs
Shipping Weight   115 Lbs
Shipping Dimensions   40" x 25" x 25"

Whole set  pressing die includes
    • Double layer structure 120mm dry pressing die
    • One 120 mm ( 4.75" I.D ) die is included, made of hardened steel and highly polished with hardness HRC 60 - 62
    • Ra 0.08?m highly polished steel
    • One stainless steel sleeve is in outside to protect die from cracking
    • Two pushing rods highly polished and perfectly fitted into die
    • Two steel support plates
    • One steel cylinder for releasing out the sample
    • Max Load: 600 metric ton (at room temperature), or 500 MPa equivalent
    • This die is designed for making 4" sputtering target
    Instruction                    
    Cautions
    • Please must always wear protection goggles during operation !!!
    • The pressing die cannot be used for pressing powder with the particle size < 30 microns. Small particles may slip into the gap between pushing rod and steel sleeve and cause damages to the sleeve during the compression. Ball mill and sieve the powder and apply only the 32~75 micron powder to the pressing die to avoid the damages. Please consider using the 3'' Dia. Sieve Set No.200&450 Mesh to separate the 32~75 microns particles from the powder clumps. Please clean the mould via ethanol after the completion of each experiment.
                 
    • Please use alcohol to clean the pressing die every time before use and store it in a dry place with antirust oil after the operation to avoid rusting on the surface, because all pressing dies are made by high-stretched carbon steel for achieving high hardness to meet essential requirements of making ceramic or metal samples. Otherwise, the pressing surface could probably get scratched.
    • To avoid damaging the die core and sleeve, we strongly recommend you use the professional laboratory hydraulic presses which ensure the most even pressing interface and uniform pressure force.
    • For pressing sticky metal powders such as Al, Mg, Zn, it is necessary to use dry or alcohol-based tool lubricant to lubricate the die and sleeve set to reduce friction during the compression.
    • Do not press flammable, explosive materials.
    Application Note
    • You may consider using EQ-BNMR for easy mold release. Please click the picture below to order.
    Steps to make sample pellet
    Warranty
    • Pressing Dies are consumable products and are not covered by MTI's warranty.
    Back to top